Runco 3Dimension D-113d Dokumentacja Pobierz pdf (Strona 67)

Installation

D-113d Projection System Installation/Operation Manual 51

PRE

IMINAR

Turning on the Power1. Power up your source components.

2. Connect an active, 1080p source to the HDMI 1 input on the 3Dimension Processor

if you have not already done so.

3. Turn on the main power switch at the rear of each DHD Controller and the

3Dimension Processor.

4. Press the ON button on the remote control (or the ON/STANDBY ( ) button on the

Primary DHD Controller front panel) to turn on the system. The vacuum fluorescent

display on the Primary DHD Controller front panel briefly displays “Initializing System,”

followed by “Starting D-113d.”

DHD (Align Secondary Image with Primary

Image)

1. Select Calibration -> Adjustment Mode

and set it to Secondary.

2. Select Calibration -> Image Alignment

-> Corner Alignment, check the Primary

Test Pattern and Secondary Test

Pattern boxes and adjust corners.

3. Select Calibration -> Image Alignment

-> Midpoint Alignment, check the

Primary Test Pattern and Secondary

Test Pattern boxes and adjust midpoints.

Projector

No adjustment needed.

Notes:

1. The Primary lens image is usually left

un-warped. This provides the best

image quality and will be un-scaled

for 1080p sources. You can adjust

the Primary image if needed,

however, by setting the

Adjustment Mode to Primary,

checking the Primary Test Pattern

and Secondary Test Pattern

boxes and adjusting the corners

and/or midpoints prior to this step.

2. The DHD Controller saves the

Image Alignment (warp) settings for

each aspect ratio. To program

additional aspect ratios, select each

one and use the controls in the

Corner Alignment and Midpoint

Alignment menus. Or, select

Calibration -> Copy/Paste ->

Aspect Ratio -> Copy Settings,

select a different aspect ratio and

choose Paste Settings.

Table 3-6. D-113d Optical Alignment Procedure (with Anamorphic Lenses) (continued)

END

The HDMI 1 input must be connected to an active 1080p source

for the optical alignment procedure that you will perform later.

Leave the AC power switch on the anamorphic lens transport in the

“off” position for now.

Note

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 151 152

Komentarze do niniejszej Instrukcji

Brak uwag

Runco 3Dimension D-113d Dokumentacja Strona 67

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Projektory danych Runco 3Dimension D-113d