Runco LIGHTSTYLE LS-HB Dokumentacja Strona 45
- Strona / 112
- Spis treści
- ROZWIĄZYWANIE PROBLEMÓW
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
Installation
Runco LS-HB/LS-HB Ultra Installation/Operation Manual 29
PRE
L
IMINAR
Y
Installing the Fixed
Anamorphic Lens Base
Plate
To install the base plate on an LS-HB with a fixed anamorphic lens:
1. Place the projector upside down on a blanket or other soft surface.
2. Secure the base plate and Ceiling Mount Plate (if used) to the projector with the four,
M4 x 0.7 x 14mm screws provided with the anamorphic lens base plate.
Figure 3-6. Projector with Fixed Anamorphic Lens Base Plate - Bottom View
1. Do not use the mounting screws provided with the ceiling
mounting kit. Use only the hardware provided with the
anamorphic lens base plate.
2. DO NOT OVER-TIGHTEN THE SCREWS.
Caution
Ceiling Mount Plate
(part of Ceiling Mount Kit)
Anamorphic
Lens Base Plate
Screw,
Phillips
Pan-Head,
M4 x 0.7 x
14mm (4x)
1
2
- LS-HB Ultra 1
- Warranty 3
- Important Safety Instructions 7
- Compliance Information 8
- Table of Contents 11
- List of Figures 15
- 1. Introduction 17
- Using This Manual 18
- Description, Features 19
- Introduction 20
- 2. Controls and Functions 21
- Controls and Functions 22
- Vertical Lens Shift 24
- LS-HB Rear Panel 25
- LS-HB Remote Control 26
- 3. Installation 29
- Installation 30
- Quick Setup 31
- Considerations 32
- Screen width (w) 33
- Ceiling Installation 35
- Floor Installation 35
- Installing the Primary 37
- Projection Lens 37
- (LS-HB Ultra only) 37
- Re-Assembling the 39
- Projector 39
- Installing the Optional 40
- Anamorphic Lens 40
- Attachment Points 41
- Mounting the LS-HB 46
- Connections to the 48
- HDMI/DVI sources (BD, DVD 49
- RGB Camcorder 50
- Gaming Console 51
- DVD/DTV STB 51
- DTV-Set-Top Box 52
- (DTV-STB) 52
- Retractable Screen or other 55
- 12-volt trigger-activated 55
- IR Repeater 56
- Zoom Out 57
- Installing and 59
- Adjusting the 59
- Too High 60
- Correct position 60
- Correct Lens Angle 61
- Incorrect Lens Angle 61
- 4. Operation 63
- Picture-In-Picture (PIP) 64
- Using the On-Screen 65
- Operation 66
- Below Black 71
- Off Crop Zoom 74
- PBP2PBP1 82
- Lamp Replacement 89
- Troubleshooting Tips 90
- 6. Serial Communications 93
- Table 6-2. Serial Commands 97
- Table 6-3. RS-232 Error Codes 103
- Serial Communications 104
- 7. Specifications 105
- LS-HB Dimensions 108
- Supported Timings 109
- 020-1093-01 Rev. A 112
- October 2011 112
Powiązane produkty i podręczniki dla Projektory danych Runco LIGHTSTYLE LS-HB
Projektory danych Runco CL-420 Dokumentacja
(72 strony)
(72 strony)
Projektory danych Runco Vision 85 Dokumentacja
(88 strony)
(88 strony)
Projektory danych Runco RS-440LT Dokumentacja
(41 strony)
(41 strony)
Projektory danych Runco VX-8d Dokumentacja
(104 strony)
(104 strony)
Projektory danych Runco XP-103DHD Dokumentacja
(126 strony)
(126 strony)
Projektory danych Runco VX-4000d Dokumentacja
(108 strony)
(108 strony)
Projektory danych Runco VX-2i Dokumentacja
(112 strony)
(112 strony)
Omnia Industries Hudební vybavení uživatelské příručky
Začínající na T
Komentarze do niniejszej Instrukcji