Runco REFLECTION CL-510 Dokumentacja Pobierz pdf (Strona 44)

Installation

32 Runco SC-1 Owner’s Operating Manual

PRE

IMINAR

3.7

Connections to the

SC-1 and DHD

Controller

Proceed as follows to connect the DHD Controller to the SC-1, your video sources,

external controller(s) – if present – and AC power.

When connecting your equipment:

• Turn off all equipment before making any connections.

• Use the correct signal cables for each source.

• Ensure that the cables are securely connected. Tighten the thumbscrews on

connectors that have them.

Input Panel Access To access the SC-1 input panel, remove

the two screws holding the input panel

cover in place.

Connecting the DHD

Controller to the SC-1

Connect the DVI, RGBHV and RS-232 outputs from the DHD Controller to the

corresponding inputs on the SC-1; see

Figure 3-13.

To minimize cable clutter, bundle the

cables together and re-attach the input

panel cover. Pass the cables through the

opening at the bottom of the cover.

➤

Remove these screws

➤

Pass cables through

this opening

Replace these screws

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 125 126

Brak uwag

Runco REFLECTION CL-510 Dokumentacja Strona 44