Runco VX-4c Dokumentacja Pobierz pdf (Strona 22)

INSTALLATION AND SETUP

2-15

Remote Keypad Protocol - IR OR WIRED KEYPAD -

The standard IR remote keypad or the optional wired remote can be set to one of two

different protocols - “A” or “B”. To hard-wire a protocol to “A” or “B” in either remote,

follow Steps 1 through 5:

Step 1

Unplug the keypad from the projector (applies to wired remote only).

Step 2

Unlatch and open the empty battery compartment on the back of the keypad as shown below.

NOTE: A wired keypad opens as shown, but a cable passes through the battery compartment

cover.

Opening the Keypad

Step 3

Find the 4 jumpers located along the latching side of the battery compartment. These jumpers set

the keypad protocol and other settings so that the keypad functions in a certain manner.

Step 4: Set the Jumpers

Set the jumpers as shown on the following page. Take care to refer to the correct part of the draw-

ing - IR or wired (optional). Use tweezers or needle-nose pliers to remove and replace each

jumper as necessary.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 109 110

Brak uwag

Runco VX-4c Dokumentacja Strona 22